Tropical Journal of Pharmaceutical Research

Original Research Article | OPEN ACCESS

Alginate-Chitosan Particulate System for Sustained Release of Nimodipine

Adhiyaman Rajendran¹ , Sanat Kumar Basu²

¹School of Pharmacy and Health Sciences, International Medical University, Kuala Lumpur, Malaysia; ²Division of Pharmaceutics, Department of Pharmaceutical Technology, Jadavpur University, Kolkata, India.

For correspondence:- Adhiyaman Rajendran Email: genomic2002@yahoo.com Tel:0060162702470

Received: 27 March 2009 Accepted: 20 July 2009 Published: 23 October 2009

Citation: Rajendran A, Basu SK. Alginate-Chitosan Particulate System for Sustained Release of Nimodipine. Trop J Pharm Res 2009; 8(5):433-440 doi: 10.4314/tjpr.v8i5.8

© 2009 The authors.
This is an Open Access article that uses a funding model which does not charge readers or their institutions for access and distributed under the terms of the Creative Commons Attribution License (http://creativecommons.org/licenses/by/4.0) and the Budapest Open Access Initiative (http://www.budapestopenaccessinitiative.org/read), which permit unrestricted use, distribution, and reproduction in any medium, provided the original work is properly credited..

Abstract

Purpose: The aim of this work was to prepare nimodipine-loaded alginate-chitosan beads for sustained drug release.

Methods: Nimodipine-loaded alginate-chitosan beads were prepared by ionic gelation method using various combinations of chitosan and Ca²⁺ as cations and alginate as anion. The swelling ability and in vitro drug release characteristics of the beads were studied at pH 1.2 and 6.8. Infra-red (IR) spectrometry, scanning electron microscopy (SEM), differential scanning calorimetry (DSC), x-ray diffraction (XRD), and atomic absorption spectroscopy (AAS) were also applied to investigate the physicochemical characteristics of the drug in bead formulations.

Results: The surface morphology, size, and drug loading of the beads varied with increase in the concentration of chitosan and calcium chloride in the gelation medium. The swelling ability of the beads in different pH media was dependent on the presence of a polyelectrolyte complex in the beads and the pH of the media. Both calcium alginate beads and the beads treated with chitosan failed to release the drug at pH 1.2 over the period of study. On the other hand, at pH 6.8, calcium alginate beads released approx. 96 % of drug in 6 h, but treatment of the beads with chitosan lowered drug release to 73 %. Drug release mechanism was either “anomalous transport” or “case-II transport”. Data from characterisation studies indicate that there was no significant change in the physical state of the drug in the bead formulations.

Conclusion: Although nimodipine-loaded alginate beads showed poor sustained release characteristics, modification with chitosan yielded beads that exhibited sustained drug release.

Keywords: Alginate-chitosan beads; Nimodipine; Swelling; Physicochemical characterization; Sustained release