Original Research Article | OPEN ACCESS
Effect of Different Crystallization Techniques on the Dissolution Behavior of Ketoprofen
Mudit Dixit ,
Parthasarathi K Kulkarni,
Rudra S Vaghela
Department of Pharmaceutics, J.S.S College of Pharmacy, J.S.S. University, S.S. Nagar, Mysore-570015, Karnataka, India;
For correspondence:- Mudit Dixit
Email: muditdixit911@yahoo.com Tel:+919035508450
Received: 24 May 2012
Accepted: 31 March 2013
Published: 12 June 2013
Citation:
Dixit M, Kulkarni PK, Vaghela RS.
Effect of Different Crystallization Techniques on the Dissolution Behavior of Ketoprofen. Trop J Pharm Res 2013; 12(3):317-322
doi:
10.4314/tjpr.v12i3.7
© 2013 The authors.
This is an Open Access article that uses a funding model which does not charge readers or their institutions for access and distributed under the terms of the Creative Commons Attribution License (http://creativecommons.org/licenses/by/4.0) and the Budapest Open Access Initiative (http://www.budapestopenaccessinitiative.org/read), which permit unrestricted use, distribution, and reproduction in any medium, provided the original work is properly credited..
Abstract
Purpose: To enhance the solubility and dissolution characteristics of ketoprofen using various crystallization techniques.
Methods: Ketoprofen crystals were prepared by various crystallization technique including spherical agglomeration (SA), spray drying (SD), freeze drying (FD) and super cooling (SC). The crystallization medium used for all the techniques consisted of water and chloroform. Residual solvents in the crystals were determined and the crystals were characterized by DSC, FT-IR, XRD and SEM. Both solubility and dissolution behavior studies were carried out. The physical stability of the crystals were also evaluated after storage over a period of time.
Results: Residual IPA and chloroform in the crystals ranged from 4.10 - 5.70 and 1.84 - 2.57 ppm, respectively, which are well below their toxic limits. The crystals obtained exhibited lower crystallinity than the original drug. The solubility of FD crystals in water increased almost fivefold to 0.0926 mg/ml compared with that of the drug (0.0172 mg/ml), while the dissolution rates of the developed crystals were than that of the original crystals. For example, FD crystals demonstrated the highest dissolution (99.9 %) compared with original crystals (64.3 %). In the stability test, the dissolution profiles of the developed crystals remained largely unchanged over the period of the stability study.
Conclusion: The re-crystallization techniques used in this study can be applied to obtain modified ketoprofen for formulation of tablets of the drug with improved drug dissolution.
Keywords: Crystallization, Ketoprofen, Crystallinity, Dissolution, Stability