Tropical Journal of Pharmaceutical Research

Original Research Article | OPEN ACCESS

Fabrication of Cationic Exchange Polystyrene Nanofibers for Drug Delivery

Todsapon Nitanan, Prasert Akkaramongkolporn, Theerasak Rojanarata, Tanasait Ngawhirunpat, Praneet Opanasopit

Pharmaceutical Development of Green Innovations Group (PDGIG), Faculty of Pharmacy, Silpakorn University, Nakhon Pathom, Thailand;

For correspondence:- Praneet Opanasopit Email: praneet@su.ac.th Tel:+6634255800

Received: 8 March 2013 Accepted: 11 January 2014 Published: 20 February 2014

Citation: Nitanan T, Akkaramongkolporn P, Rojanarata T, Ngawhirunpat T, Opanasopit P. Fabrication of Cationic Exchange Polystyrene Nanofibers for Drug Delivery. Trop J Pharm Res 2014; 13(2):191-197 doi: 10.4314/tjpr.v13i2.4

© 2014 The authors.
This is an Open Access article that uses a funding model which does not charge readers or their institutions for access and distributed under the terms of the Creative Commons Attribution License (http://creativecommons.org/licenses/by/4.0) and the Budapest Open Access Initiative (http://www.budapestopenaccessinitiative.org/read), which permit unrestricted use, distribution, and reproduction in any medium, provided the original work is properly credited..

Abstract

Purpose: To prepare polystyrene nanofiber ion exchangers (PSNIE) with surface cation exchange functionality using a new method based on electrospinning and also to optimize crosslinking and sulfonation reactions to obtain PSNIE with maximum ion exchange capacity (IEC).

Method: The nanofibers were prepared from 15% w/v polystyrene solution in dimethylacetamide (DMAc) containing 0.025 %w/v tetrabutylammonium bromide (TBAB) using electrospinning technique, followed by crosslinking with sulfuric acid/formaldehyde in a ratio ranging from 100/0 to 50/50 v/v and sulfonation in sulfuric acid. Degree of crosslinking was determined as the amount of fibers that remained in dichloromethane. The morphology and diameter of the fibers were evaluated by scanning electron microscopy (SEM) while IEC of PSNIE was performed by salt splitting titration.

Results: PSNIE crosslinked with a sulfuric acid/formaldehyde ratio of 90/10 with 0.1 %w/v silver sulfate for 10 min at 70 ° C and sulfonated in 98 % sulfuric acid with 0.2 %w/v silver sulfate as the catalyst at 100 ° C for 30 min showed a maximum IEC of 3.21 meq/g-dry-PSNIE. Increase in sulfonation temperature caused the IEC of PSNIE to increase due to faster sulfonation. It was observed that the higher the temperature the faster the rate of sulfonation reaction. The diameter of the fibers after sulfonation was 404 ± 42 nm.

Conclusion: These results indicate that PSNIE can be successfully prepared by electrospinning. Furthermore, cationic drug can be loaded onto the novel PSNIE for controlled release delivery.

Keywords: Polystyrene, Ion exchange capacity, Nanofibers, Ion exchangers, Crosslinking, Sulfonation