Mahesh M Reddy,
Jagadeeswara D Reddy,
Afrasim Moin ,
H G Shivakumar
JSS College of Pharmacy, JSS University, Mysore, Karnataka-570015, India;
For correspondence:- Afrasim Moin
Email: afrasimmoin@yahoo.co.in Tel:+919886652844
Received: 16 February 2011
Accepted: 3 December 2011
Published: 21 February 2012
Citation:
Reddy MM, Reddy JD, Moin A, Shivakumar HG.
Formulation of Sustained-Release Matrix Tablets Using Cross-linked Karaya gum. Trop J Pharm Res 2012; 11(1):28-35
doi:
10.4314/tjpr.v11i1.4
© 2012 The authors.
This is an Open Access article that uses a funding model which does not charge readers or their institutions for access and distributed under the terms of the Creative Commons Attribution License (http://creativecommons.org/licenses/by/4.0) and the Budapest Open Access Initiative (http://www.budapestopenaccessinitiative.org/read), which permit unrestricted use, distribution, and reproduction in any medium, provided the original work is properly credited..
Abstract
Purpose: To develop sustained release matrix tablets of diltiazem hydrochloride (DTZ) using modified karaya gum (MK).
Methods: MK was prepared by cross-linking karaya gum with tri-sodium tri-metaphosphate (STMP) which was used as a cross-linker. Matrix tablets of DTZ were prepared using varying ratios of unmodified karaya gum (K) and MK by direct compression. The matrix tablets were evaluated for pharmacotechnical properties and in vitro release, including release kinetics. The optimized formulation was compared with Dilzem SR which served as reference. MK and the formulations were also characterized by scanning electron microscopy (SEM), Fourier transform infra-red spectroscopy (FTIR) and differential scanning calorimetry (DSC).
Results: Tablets with MK showed higher mean dissolution time (MDT) and lower dissolution efficiency than those prepared with karaya gum. Drug release was by water uptake, diffusion and erosion mechanisms. Drug release from tablets formulated with unmodified K at the end of 10 h was 99.9 %, and while for MK tablets, it was 68.2 % at the end of 12h. MK sufficiently controlled drug release unlike K which exhibited poor sustained drug release. Formulation F6 compared well with the reference, Dilzem SR (p <0.05), in terms of release characteristics. Cumulative drug release at the end of 12 h for both test and reference formulations was approx. 85 %. SEM images of the tablets before and after dissolution showed some morphological differences on their tablet surfaces while FTIR and DSC thermogram studies confirmed that there was no chemical interaction between the drug and the polymers in MK formulation.
Conclusion: The results of the study demonstrate that modified karaya gum has good potentials for formulating suitable sustained-release matrix tablets of diltiazem.
Keywords: Karaya gum, Diltiazem hydrochloride, Tri-Sodium Tri-metaphosphate, Crosslinking, Matrix tablets, Sustained release